Rohini Invisible Grills
Fit Madhapur invisible grills into the order of your renovation
Planning invisible grills during a Madhapur flat fit-out? Coordinate fixing surfaces, paint, cable measurements and handover before confirming the installation quote.
Agree the cable position before finishes conceal the structure
Invisible grills use slim cables and supporting fittings, not a single wire supplied by the metre. For a Madhapur renovation, show Rohini the proposed opening before cladding or ceiling panels cover potential fixing surfaces. Identify the intended purpose of the barrier and ask for the complete assembly to be assessed; decorative finishes cannot be assumed to carry it.
Separate the measurement visit from the fitting date
Dimensions can change when a sill, floor or wall finish is added. Ask which measurements are preliminary and which must be confirmed after other work. Keep the carpenter and painter informed about the assessed fixing line. A convenient date on the renovation calendar should not override unfinished structural repairs or unresolved access requirements.
Accept the installed system after the other trades finish
Check whether later painting or equipment work could disturb cables or anchors. Keep the specification, approved drawing and care instructions together, and report any subsequent damage instead of adjusting cable tension yourself. Required guards and supervision remain necessary; adding an unobtrusive cable barrier does not make an open edge accident-proof.
Pre-finish planning versus a completed-room retrofit
| Decision point | Coordinate during the fit-out | Assess after decoration |
|---|---|---|
| Information | Supporting surfaces can be discussed before they are concealed. | Existing finishes may need further investigation before an anchor position is agreed. |
| Measurements | The final finish line must still be confirmed before fabrication. | The finished opening is visible, but trim may restrict the available fixing line. |
| Responsibility | Allocate protection and making-good work between the appointed trades. | Include protection of occupied rooms and finished surfaces in the retrofit scope. |
Madhapur fit-out quote: allow for coordination
- Separate openings, side returns and the chosen cable specification determine the supplied assembly.
- Revisits after altered finishes or an approved change of fixing position can affect labour and fabrication.
- Ask whether surface investigation, protection and finish repairs are included; compare the total scope, not only a square-foot figure.
Arrange access to the Madhapur renovation
- Share the Madhapur, Hyderabad map pin, flat number and the person coordinating site entry; confirm that an assessment slot is available.
- Send the latest opening drawing with the current finish stage and identify work scheduled near the proposed cables.
Sequencing questions before the cable order
Should I order cables from the architect's initial opening dimensions?
Use the drawing for discussion, then ask the installer when final dimensions can be confirmed. Changes to finishes or support details may alter the required assembly.
Can a painter temporarily loosen the wires?
Do not treat cable adjustment as ordinary paint preparation. Contact the installer about an agreed procedure and any inspection needed before the opening is used again.
Discuss Madhapur grill work alongside your fit-out
Tell Rohini which trades are still working and when the opening will be ready for assessment. Request a written installation scope linked to the final finish details.
